Replacing The Bulb; Accessories - ANSMANN Starlight Serie Mode D'emploi

Operating Instructions
GB
ANSMANN Starlight Series
Starlight 200 (UK) and Starlight 400 (UK)
(Starlight 300 – no longer available)
Page 2
FOCUS
You can adjust the focus by turning the zoom grip (4). Turning the zoom grip fully clockwise will cause the bulb
selected by (1) to flash on and off.

REPLACING THE BULB

Press the rubber ring of the reflector at the two tabs (10). The reflector/lens can now be taken out of the lamp
case and the bulbs can be replaced.

ACCESSORIES

Starlight 300 and 400 are supplied with a shoulder strap. It can be fastened to the two fixings on the upper sides
of the case.
Starlight 400 is supplied with two coloured filter slides (red and green). The power pack case provides storage
for the two slides.
MAINS-FAILURE DETECTION
Starlight 400 has a mains-failure detection option. This means that the lamp will automatically switch on if it
detects that there is a mains failure, to provide a safety light. When the lamp is placed into the wall bracket for
charging with the light on, the bulb extinguishes. If it detects a mains failure, the bulb will light until the mains
power is restored and the power pack is being charged again.
REMOVAL OF THE RECHARGEABLE BATTERY PACK (8)
Depress the two release positions (6) at the same time to remove the power pack.