Mounting Of The Wall Bracket; Operating Time; Using The Lamp - ANSMANN Starlight Serie Mode D'emploi

Operating Instructions
GB
ANSMANN Starlight Series
Starlight 200 (UK) and Starlight 400 (UK)
(Starlight 300 – no longer available)
Page 1
CAUTION !
This appliance has to be charged for 24 hours before using it for the first time. The lamp can be
charged continuously, i.e. the charging adaptor can remain permanently in the mains socket and the
appliance in the wall bracket (9).

MOUNTING OF THE WALL BRACKET (9)

Drill two holes 110 mm apart vertically where you wish to fix the wall holder. We recommend that you fit the
wall holder to the wall near a mains socket checking that the holes to be drilled are well away from the mains
supply cable to the electrical socket. Fit the wall plugs into the holes, position the wall holder against the wall,
insert screws and screw up tightly.
CHARGING THE LAMP
Before using the appliance for the first time charge it for at least 24 hours in the wall bracket (9). The charging
unit can remain in the mains socket. This means that the lamp is constantly charged in the wall bracket. The LED
(7) indicates that the appliance is being charged. When fully charged the lamp provide its full power.

OPERATING TIME

For appropriate operating time of your STARLIGHT model please refer to the table H (page 3).

USING THE LAMP

Before using the lamp take it out of the wall bracket (9). All Starlight lamps have a handle that can be moved by
180 degrees and be folded back in four different positions. The angle can be adjusted by moving the handle
forward or backwards whilst pressing the release key (5). With the slide switch (1) you can switch on the lamp.
The Starlight 300 and 400 have two switch positions. First step: Krypton; second step: Halogen