The right refrigerator door does not have an
adjustable nut.
If the space between the doors is uneven, follow the
instructions below to align the right door:
1
With one hand, lift up both the inner and outer
door sections of the right door to raise them at the
middle hinge. (It may be easier to lift it with the
doors open.)
2
With the other hand, use pliers to insert the snap
ring on the middle hinge of the inner door section
as shown. Do not insert the ring on the hinge of
the outer door section.
3
Insert additional snap rings until the right door is
aligned. (Two snap rings are provided with the
unit.)
Turning on the Power
• After installing, plug the refrigerator's power cord
into a 3-prong grounded outlet and push the
CAUTION
• Connect to a rated power outlet.
•
and wiring for proper grounding.
• Do not damage or cut off the ground terminal of
the power plug.
Position the Refrigerator
• Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
Start the Icemaker
• If the water line is connected, set the icemaker
power switch to the ON position.
• The icemaker will not begin to operate until it
reaches its operating temperature of 15 °F (–9 °C)
or below. It will then begin operation automatically if
the icemaker power switch is in the ON (I) position.
INSTALLATION
27