Assembly and setup
If assembly is required, it can be done with common hand tools. When special tools are
required, they are supplied with the scale. Ensure that all bolts and fasteners are
securely tightened.
Use the following instructions to assemble and setup your scale for use.
Note
Models 6702, 6702SP, and 6702W wheelchair scales
1. Carefully remove all parts from the shipping carton and inspect the components for
shipping damage.
2. Place the scale base on the floor or on a workbench.
3. Remove the bolts and washers from the rear of the scale base.
4. Insert the mast into the base. Ensure that the readout display is facing the patient
when the patient stands on the scale.
5. Fasten the mast with the bolts and washers removed in Step 3.
6. Tighten the bolts securely to ensure a solid connection is made.
Weighing deck mounting
1. Position the weighing deck so that the two sets of holes under the flaps are closest
to the mast.
2. Line the weighing deck up with the mounting holes in the aluminum plate.
3. Install the 10 flat head screws through the weighing deck.
4. Securely tighten the supplied mounting screws with the provided hex key.
Handrail mounting (purchasable option)
If your scale was purchased with an optional handrail, follow the installation instructions
included with the handrail.
Height gauge assembly (purchasable option)
If your scale was ordered with a height gauge, follow the installation instructions
included with the height gauge.
If your scale requires assembly, make sure that the serial number of the
mast and the serial number of the base match when assembling.
9