Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Unpack all parts and remove protective material.
•
Connect the Power Cord to AC outlet. Press the power On/Off knob to switch the system on.
•
Slide the counter weight (25, see depicted below) onto the tone arm, until it reaches the end. Turn
clockwise until it clicks with pit inside. Twist the counter weight clockwise and backward until it reach-
se the white inner line (see below fig. 2). Twist the counter marking until position 1 is reached. Twist the
counter weight anti-clockwise and inward until the appropriate working pressure is adjusted.
•
Remove the stylus cover and make sure the tone arm had been loosened from the tone arm holder.
•
Switch to PHONO (12) and adjust the appropriate PITCH and RPM (27 / 28)
•
Place a record on the platter. Use the spindle adaptor ("Puck") if necessary.
•
Gently lift the tone arm from the holder and slowly push it toward the record edge. Let it float over the
desired position/track, then press CUE, to lower the needle.
•
When no record is playing, place the tone arm on the holder.
•
Press RETURN (14) to lift the pickup at any point and return it to the pickup holder.
Please note: Deactivate the auto-stop function if the auto stop area of your record is smaller than
usual.
12
Operation
Connection
Phono Deck
Publicité
Table des Matières
