NOMA Loen Manuel D'instructions page 6

6
Toll Free: 1-866-827-4985 model no. 052-9337-2
ASSEMBLY
Installation: The installation is to be in accordance with the National Electric Code, ANSI/NFPA 70 and local codes.
1. Mounting bracket
Note: The mounting bracket depicted will vary
depending on the model.
Remove the four sets of side screws from mounting
.
bracket and save for future use.
Wooden ceiling
. Drill two mounting holes in the ceiling joist. Securely
attach the mounting bracket to the ceiling or wooden
ceiling as indicated below (see FIg. 4a).
Normal masonry ceiling
. Securely attach the mounting bracket to an
outlet box marked"Acceptable for Fan
Support", using the supplied outlet box
screws with lock washers (see Fig. 4b).
2. Attach blade assembly to motor
Using the fan blade screws and washers, attach the fan
.
blades to the blade arms. (see Fig. 5)
. If there are plastic tabs shaped like bottle caps, remove
and discard them. These are stabilizers that protect the
motor during shipping.
. Remove blade bracket screws on the bottom of the motor
and use them to attach the blade assembly to the motor.
Ensure that the screws are tightened (see Fig. 6).
3. Hands-free wiring
.
Carefully lift the fan assembly onto the mounting
bracket.
.
Rotate the fan until the notch (b) on the aluminum
ball fits against the ridge (a) on the mounting
bracket (see Fig. 7a).
. With the mounting bracket holding the fan assembl y,
follow wiring instructions (step 4).
Mounting
bracket
4a
wood screw
4b
Lock washer
Outlet box screw
5
Blade Arm
6
7a
a
b
Flat
washer
Blade