Functions; Defrosting; Shelves - Summit Classic Collection CL65ROS Manuel D'utilisation

Functions

 Temperature Memory Function
If the power is suddenly lost, the set temperature will
be remembered by the unit and once the power is
back on, the unit will be at the same set
temperature.
 "Close Door" Reminder Function
When you forget to close the door or the door
is not fully closed, there will be a warning alarm
after 5 minutes.
 Temperature Alarm Function
If the inner temperature is higher than 73° F
(23°C),"HI" is shown on the display panel and
the alarm buzzer will sound continuously after one
hour.It informs you that the inner temperature is
too high. Please check for the cause.
If the inner temperature is lower than 32° F(0° C),
"LO" is shown on the display panel; the alarm
buzzer will sound and the malfunction indicator
will light at the same time.
NOTE:If too many bottles are put in at once or the
door has not been closed tightly, the unit will
display the "HI" signal on the display panel.
This is normal. Please wait 5 minutes after you
close the door and "HI" will disappear.
 It is normal that the cabinet shows "HI" or "LO"from
time to time. If it occurs frequently or lasts for a long
time, you can restart the unit by unplugging it. If the
problem occurs once again after restart, please
contact customer service.
 Before reconnecting the power plug into a
socket, wait 3 to 5 minutes. Otherwise you could
damage your appliance. If you attempt to turn on
the appliance before the end of this time delay,
the appliance will not start.
If you turn on the appliance for the first time or after

a restart, or after it has been out of operation for a
long time, there may be a temperature difference
between the temperature inside the appliance and
on the LED display. This is a normal event caused
by the duration of the activation period. Leave the
appliance turned on for several hours and the
temperatures will stabilize during operation.
Operation

Defrosting

There is no need to defrost your appliance
manually since its operation is frost-free.

Shelves

Do not cover racks with aluminum foil or
any other material that will prevent
adequate air circulation within the
cabinet
 To prevent damaging the door gasket, make sure to
have the door open all the way when pulling
shelves out of the
rail compartment.
For easy access to the storage contents, you must

pull the shelves approximately 1/3 out of the rail
compartment. Note that this unit was designed with
a notch on each side of the shelf tracks to prevent
bottles from falling.
When removing any of these shelves from the rail

compartment, you must first disassemble and
remove the plastic posts by removing the lock
screw that holds each post in place. (Fig. A)
To re-install, ensure the shelf is resting securely on

the support brackets and push shelf inward until it
locks into place.
10
.