Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SHAFT SUPPORT
Insert the bar support on
the shaft and fasten it with
M8 screws
Insert the bar in the support
and tighten the screws
OPENING DIRECTION
To change the direction of opening from the left (standard) to the right proceed as
follows:
DX
DX
„ Release the spring
„ Remove the trapezoidal bracket
by unscrewing the two screws.
To remove the trapezoidal bracket,
use an extractor
„ Change the position of the key
from position A to position B.
To remove the key, screw the 5x20
screw (A) in the hole up to the
complete extraction.
Screw A
Screws
Trapezoidal
bracket
Key
Position A
Screw
Bar
support
Screws
Position B
Key
Shaft
SX
SX
B
A
Publicité
Table des Matières
