Ugolini MT MINI UL Carnet D'instructions page 8

MT MINI UL
5. 3. 3 SANITIZING
Sanitizing should be performed immediately prior to
starting the machine. Do not allow the unit to sit for
extended periods of time after sanitization.
1 Wash hands with a suitable antibacterial soap.
2 Prepare at least two gallons of a warm (45-60 °C 120-
140 °F) sanitizing solution (100 PPM available chlorine
concentration or 1 spoon of sodium hypoclorite diluted with 2
litres of water) according to your local Health Codes and
manufacturer's specifications.
3 Place the parts in the sanitizing solution for five minutes.
4 Do not immerse the lighted top covers in liquid. Carefully
wash their undersides with the sanitizing solution.
5 Place the sanitized parts on a clean dry surface to air dry.
6 Wipe clean all exterior surfaces of the unit. Do not use
abrasive cleaner.
5. 3. 4 ASSEMBLY
1 Slide the drip tray into place.
2 Lubrificare il pistone rubinetto e il rotore magnetico esterno
(see points A, B and C of figure 11) only with the grease
supplied by the manufacturer or other food grade approved
lubricant.
figure 11
3 Assemble the faucet by reversing the disassembly steps
(see figure 10)
4 Fit bowl gasket around its seat.
Note: the largest brim of gasket must face against the rear wall
(see figure 12).
figure 12
5 Insert the magnetic outside rotor in the evaporator taking
care to accompany it to the end (see figure 13).
6 Install the outer spiral. Slide it over the evaporator until its
hexagonal front notch engages with the hexagonal exposed
end of the magnetic outside rotor (see figure 14).
7 Push the bowl towards the rear wall of the unit until it fits
snugly around the gasket and its front fastening hooks are
properly engaged (see figure 15).
8 Use fresh product to chase any remaining sanitizer from the
bottom of the bowl(s). Drain this solution. Do not rinse out the
machine.
5. 4 IN-PLACE SANITIZATION
The In-Place Sanitization prior to starting the machine may
be performed, if needed, only as further precaution, in
addition to the Disassembled Parts Sanitization described
before, but never in lieu of it.
8
figure 13
figure 14
figure 15