Assembling - poolstar Z-RAY RANGER Serie Manuel D'instruction

ASSEMBLING

Note: Note:
If the boat is inflated during cold weather or without direct sunlight on the tubes,
care must be taken not to over-inflate the tubes. As the air inside the tubes heats
up due to temperature rises or sunshine, the pressure will increase. The boat is
not fitted with a safety valve, so the pressure must be monitored at all times.
- Select a clean area free of stones, gravel, sticks or other sharp objects.
- Carefully unfold the boat, spreading out the tubes and floor to make them as
smooth as possible.
NOTE: For ease of install, it is preferable to set up the boat on a warm and sunny
day. If time permits, expose the unrolled boat to direct sunlight for 1 hour or more,
so that the boat material will be more flexible during installation.
CAUTION: DO NOT DRAG THE BOAT, AS IT MAY TEAR THE BOAT OR
CAUSE OTHER DAMAGE.
Install the floor:
- Install the floor in numbered sequence. Number 1 is a wooden board, numbers
2-4 are aluminium.
When number 1 is in position, slide number 2 up to number 1 and insert the
leasing edge of number 2 into the grooved rear of number 1. Position the number
3 leading edge into the
grooved rear of number 2.
Position the rear edge of
number 4 into the back of
the boat. Lift the rear edge
of number 3 to the front
of number 4. Both lifted
above the floor, connection
of 3 and 4.
Adjust each board to live
up down each side fix
the sides lock bars into
position with the wide side
down. Adjust until the side
lock bars slide onto the
floor boards.
21
7 www.zraysports.com ZBII1-18-GB