Jimmy JV85 Pro Mode D'emploi page 8

Charging of vacuum cleaner
When the vacuum cleaner power is insufficient,
charge the vacuum cleaner in time ; When the
voltage is too low,to protect the battery, vacuum
cleaner will be automatic power-off,at this time
the vacuum cleaner need to be charged.When
charging, plug the charger connector into the A/C
power socket,hang the handheld vacuum cleaner
on the holder to start charging.When the handheld
vacuum cleaner LED display shows an increase
in power, it indicates that the vacuum cleaner
is charging. When charging is completed, LED
display show 100% power.
After charging, please pull the charger plug off power
socket and stop charging.
Attention: if power cord is damaged, to avoid danger, it must
be replaced by a professional people of the manufacturer,
repair ing agent or similar department.
Use of Handheld Vacuum Cleaner
Take the vacuum cleaner off the holder, press the
switch button on the handle to start or stop of the
vacuum cleaner. When machine is turned on, it
works in normal power mode, press the power
button to switch to turbo or max power mode.
Use of Flexible Metal Tube
The flexible metal tube has two modes: vertical
and bending. The vertical mode is equivalent to the
normal metal tube. The bending mode can be used
for cleaning under the tablebottom,bed bottom,
etc. When the bending mode i sneeded,press the
bending button as shown in the following figure,
and the metal tube can achieve 0-90°bending
angle.
Use of Electric Floor Head
Clean hardfloor, tile or carpet with the electric
floorhead. Carpet brushroll can be replaced to the
floorhead to clean long hair carpet.
6
6
Switch button
8
Power button
LED screen
Dust release button
9
10
Clean hardfloor, tile
or short hair carpet.
7
Battery pack
release button
Bend button ing
Carpet brushroll
C l e a n l o n g h a i r
carpet.