Operating Dmm 4/2/2 - AKG DMM 4/2/2 Mode D'emploi

Operation

Operating DMM 4/2/2

38
To operate the rotary controls on the front panel of the DMM 4/2/2:
M I C / L I
I N 2 -
Figure 9: Operation of the rotary control
Turn the rotary control clockwise or counter-clockwise to make changes to inputs and outputs
and function settings (see "DSP functions" Page 39). These changes are shown on the LED
ring around the rotary control. The starting point and the increments on the LED ring will vary
according to function.
Audio level display:
If the LEVEL (Page 39) function is selected, the set level is displayed on the LED rings of the
inputs and outputs.
NOTE
Briefly pressing the "SYSTEM CONTROL" rotary control switches the display on the LED rings
to VU meter, the display of the actual audio level present. As long as the VU meter mode is
activated, the LEVEL LED flashes on the "SYSTEM CONTROL" rotary control. Pressing the
"SYSTEM CONTROL" rotary control again deactivates the VU meter mode.
Adjust the properties of an input or output signal with the available functions (see "DSP
functions" Page 39):
1) Select the desired function on the "SYSTEM CONTROL" rotary control. Turn the rotary
control until the LED next to the desired function lights up.
2) Use the rotary controls to adjust the input channels with the selected function.
3) Use the "OUT MASTER" rotary control to adjust the output channel with the selected
function.
The recording output has no settings.
Ten seconds after the last change, the "SYSTEM CONTROL" rotary control goes back to the
"LEVEL" function.
NOTE
N E
DMM 4/2/2