Zehnder RFZ Manuel page 20

Assembly
1. Use the screws supplied to fit locking plate A (fig.
3) to a flush outlet, or directly onto the wall using
the screws and plugs. The 'TOP' marking should be
visible at the top end of the locking plate.
You can also affix locking plate A (fig. 4) onto a
smooth/level surface (no metal surface) by means of
the self-adhesive strips (D).
2. Place cordless switch C (fig.5) into frame B, until it
clicks into position.
3. Place the cordless switch and frame approx. 5 mm
above locking plate A and lower it until it clicks tight
into the fastening lugs of the locking plate. (fig.6)
Note: The remote control is IP40 classified and
should therefore be fitted in zone 3.
20 - EN