Safety Information; Installation And Assembly - Master MAC-36-BDF Manuel De L'utilisateur Et Instructions D'utilisation

WARNING
WARNING
WARNING
WARNING
- Before operating always check fan for loose or dam-
aged parts. Inspect power cord for damage. Never
use fan without safety guards attached.
-Operate only on 120 volt 60 Hz (cycle) current with a
minimum 15 amp circuit.
- When used with an extension cord, use a UL listed,
14 AWG cord equipped with a receptacle to accept
the three-prong grounded plug on the fan's power
cord and a 3-prong grounded plug for the power
source. If extension cord is longer than 50 feet,
consult with cord manufacturer for proper cord AWG
rating. Always keep power cord and extension cords
away from heat, oil, and sharp edges. Inspect cords
periodically and replace if damaged.
Operation
NOTE: This fan is equipped with a 2-speed con-
trol switch.
TO START FAN:
1. Be sure the Power Switch is in the (OFF)
position.
2. Connect to an approved power source.
3. Make sure area is clear from all obstructions.
4. Push the Power Switch to the LOW position
and allow to operate for 10 seconds.
5. Once 10 seconds have passed, you may now
push the Power Switch to the HIGH position.
TO TURN OFF FAN:
1. To turn off the fan, simply return the Power
Switch to the middle (OFF) position.
NOTE: For longer parts life, after 10 hours of
continuous operation, turn fan off for 15 minutes
to allow motor and fan belt to cool.
© 2018, Pinnacle Climate Technologies, Inc.
NEVER LEAVE A FAN UNATTENDED WHILE OPERATING
OR WHILE CONNECTED TO A POWER SOURCE

Safety Information

To reduce the risk of electric shock, do not expose to water or rain.
This unit is designed for indoor use only.
Installation work and electrical wiring must be done by qualified per-
son (s) in accordance with all applicable codes and regulations.
When Servicing or replacing a component requires the removal or
disconnection of a safety device, the safety device is to be rein-
stalled or remounted as previously installed before operating this
fan.
Use this fan only in the manner intended by the manufacturer. If you
have any questions, contact Customer Service at 800-779-3267.

Installation and Assembly

Attaching The Wheels (Figure 1)
1. Slide wheel axle through wheel support
frame.
2. Slide one (1) wheel onto either side of axle.
3. Secure each wheel with one (1) cotter pin.
1
Figure 1
4. Locate fan in a safe, desired position on level
ground, and connect to approved power
source.
WARNING
fan or return to an authorized service facility
for examination and/or repair. Do not run
cord under carpeting. Do not cover cord with
throw rugs , runner, or similar coverings. Do
not route cord under furniture or appliances.
Arrange cord away from traffic areas and
where it will not be tripped over.
1
High Capacity Barrel Fan User's Manual
2 3
Do not operate any
fan with a damaged
cord or plug. Discard