Rockford Fosgate ELEMENT READY M2D4-10I Mode D'emploi page 10

Wiring
SPEAKER Wiring
There are (2) different options for wiring your speakers.
Use the included spade connectors (included) as seen in illustra-
tion 3.1
You can also utilize the DEUTSCH™/Amphenol style connector
(not included) input next to the COLOR OPTIX™ connector.
COLOR OPTIX™ Wiring
If not using the PMX-RGB, follow the diagrams below for proper
pin out and hard wiring instructions.
COLOR OPTIX™ Wiring Precautions
• Do not connect to 24 Volt electrical systems
• We recommend only using the COLOR OPTIX™ wiring chart
or connecting to the PMX-RGB. Connecting any other way
could cause damage to the speakers or the device you have
connected to.
• We recommend installing a fuse (not included) on the
Yellow 12 Volt wire whenever you are NOT using the PMX-
COLOR OPTIX™. See COLOR OPTIX™ wiring chart for wiring
options.
• Rockford recommends a minimum of 20 gauge wire when
hard wiring your COLOR OPTIX™ speakers.
• Never wire the COLOR OPTIX™ lights directly to 12 volts.
Utilize either the PMX-RGB or a toggle switch (not included)
connected to a fused 12 volt power supply. Refer to the
specification to determine the size of fuse (not included)
needed
COLOR OPTIX™ Pin Out (wire side)
1 2
3 4
illus.-4.1
10
1 - RED (Ground Input)
2 - Yellow (12V + Input)
3 - Blue (Ground Input)
4 - Green (Ground Input)
Included with speakers
™
Connector is DEUTSCH /Amphenol style
Speaker Pin Out (wire side)
1 - RED - Positive Speaker Input
2 - BLACK - Negative Speaker Input
NOT included with speakers
Connector is DEUTSCH
COLOR OPTIX™ WIRING OPTIONS
LED OUTPUT COLOR
RED
GREEN
BLUE
YELLOW
PINK
AQUA
WHITE
Connect colored wires on right to make output color
on left.
Connect all Yellow wires together to switched 12
Volts. See Wiring Precautions.
COLOR OPTIX™ Connector
Included
DT06-4S
1 2
illus.-4.3
™
/Amphenol style DT06-2S
CONNECT THIS COLOR WIRE
TO GROUND
RED
GREEN
BLUE
RED & GREEN
RED & BLUE
GREEN & BLUE
RED, GREEN & BLUE
illus.-4.2