Before Starting The Equipment; Cleaning, Maintenance And Ordering Of Spare Parts - Pattfield Ergo Tools E-ASS 4,8 V Mode D'emploi

Anleitung_E_ASS_4_8_V_SPK7:_

5. Before starting the equipment

Be sure to read the following information before you
use your cordless screwdriver for the first time:
1. Charge the battery pack with the charger
supplied.
2. Only ever use screwdriver bits which are suitable
for the purpose and in faultless condition.
3. Always check for concealed electric cables and
gas and water pipes when drilling and screwing
in walls.
6. Operation
6.1 Charging the battery
1. Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Plug the battery charger in the socket-outlet and
connect the charging cable to the charging
connection.
2. The red LED (9) will come on to indicate that the
battery pack is being charged.
3. An empty battery pack requires a maximum
charging period of 7 hours. The temperature of the
battery pack may rise slightly during the charging
operation. This is normal.
Important! The charger does not switch off
automatically when the battery pack is fully
charged!
When charging is finished, remove the screw-
driver from the charger.
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet
and check for proper contact with the charging
contacts in the battery charger.
If the battery still fails to charge, send
the battery charger
and the screwdriver
to our customer services department.
Timely recharging of the battery pack will help it
serve you well for a long time. You must recharge
the battery pack when you notice that the power of
the screwdriver drops.
Never allow the battery pack to become fully
discharged. This will cause it to develop a defect.
03.01.2008 8:33 Uhr Seite 9
6.2 ON/OFF and forward/reverse
changeover switch (4)
You can select between clockwise and counter-
clockwise rotation. Change the direction of rotation
only when the screwdriver is at a standstill. If you fail
to observe this point, the gearing may become
damaged.
6.3 Lighting (1)
The lamp (1) enables the work area to be illuminated
in unfavorable lighting conditions. You can switch on
the lamp with the switch (6).
6.4 Angle setting
The screwdriver can be locked in 3 different angle
settings. To do so, press and hold the locking button
(8) and move the screwdriver into the desired
position. Then release the locking button (8).
Important! Before you switch on the screwdriver,
make sure that it is correctly locked in the angle
position in question.
6.5 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
GB
9