Klarstein 10031434 Mode D'emploi page 33

Functions in Detail
1 ON/OFF Press this button to turn on the unit .Press this button again to turn off the unit.
Press this button to decrease set temperature. Holding it down above 2 seconds rapidly
2 [-]
decreases set temperature. In AUTO mode, set temperature is not adjustable.
Press this button to increase set temperature.Holding it down above 2 seconds rapidly
3 [+]
increases set temperature. In AUTO mode, set temperature is not adjustable.
Each time you press this button,a mode is selected in a sequence that goes from AUTO,
COOL,DRY, FAN,and HEAT (only for models with heating function), as the following:
AUTO > COOL > DRY > FAN > HEAT. After energization, AUTO mode is defaulted. In AUTO
4 MODE
mode, the set temperature will not be displayed on the LED of the indoor, and the unit will
automatically select the suitable operation mode in accordance with the room tempera-
ture to make indoor room comfortable.
This button is used for setting Fan Speed in the sequence that goes from AUTO > Low
5 FAN
speed > Low-Medium speed > Medium speed > Medium-High speed > High speed.
Press this button to set up & down swing angle, which circularly
changes as right picture. This remote controller is universal. If any
6 SWING
signal is sent out, the unit will carry out the command as [
[
Press this button to turn on I FEEL function. The unit automatically adjust temperature
7 I FEEL
according to the sensed temperature. Press this button again to cancel I FEEL function.
Press this button to achieve the on and off of healthy and scavenging functions in operation
status. Press this button for the first time to start scavenging function; LCD [
the button for the second time to start healthy and scavenging functions simultaneously;
8
LCD displays [
functions simultaneously. Press the button for the fourth time to start healthy function;
LCD display [ ]. Press this button again to repeat the operation above.
Press this button, can select Sleep 1 [
circulate between these, after electrified, Sleep Cancel is defaulted.
Sleep 1 is Sleep mode 1, in Cool, Dehumidify modes: sleep status after run for one hour,
9 SLEEP
the main unit setting temperature will increase 1°C, setting temperature increased 2°C, the
unit will run at this setting temperature; In Heat mode: sleep status after run for one hour,
the setting temperature will decrease 1°C, 2 hours, setting temperature will decrease 2°C,
then the unit will run at this setting temperature.
33
] indicates the guide louver swings as
]. Press this button for the third time to quit healthy and scavenging
].
], Sleep 2 [ ], Sleep 3 [ ] and cancel the Sleep,
]. Press