ARIETE 2762 Mode D'emploi page 9

how To InsTAll The ApplIAnce
warning
Switch off the appliance and remove the plug from the socket before inserting or removing the indi-
vidual parts.
- Insert the handle (K) in the body of the motor (M) until you hear a "click" (Fig. 2). To disconnect the handle
from the motor body press the release button (J) and pull the handle upwards.
- Insert the brush (A) into the motor body. Press gently until it clicks (Fig 3).
InsTrucTIons for use
warning
Disconnect the power plug from the outlet when the appliance is not used.
- Totally unwind the power cord.
- Always hold the product and check that the ON/OFF switch is in the OFF position. Plug into the mains
socket.
- Press the ON/OFF switch (I). Turn the control button (I) and set the suction power (Fig. 4).
- Clean large surfaces pushing the brush back and forth: this allows the vacuum cleaner to collect the frag-
ments and dirt from the floor.
- Press the brush switch (O) to position (
brush switch (O) to position (
- Press the ON/OFF switch (I) to turn off the appliance.
- Store the power cord in the storage compartment (Fig. 12).
warning
Switch the appliance off immediately in the event that something gets trapped inside the brush, such
as a piece of cloth, the fringes of a carpet, etc.
Check the filters regularly and, if necessary, brush them or replace them.
cleAnIng
warning
Never immerse the motor body, the plug and the power cord in water or other liquids. Use a damp cloth
for cleaning them.
Switch off the appliance and remove the plug from the outlet before inserting or removing parts and
before cleaning.
- Clean plastic parts with a damp, non-abrasive cloth and dry them with a dry cloth. Do not let any kind of
liquid enter into the appliance. Never use solvents which may damage the plastic parts.
how to empty the dust container
Clean the dust container (B) and the filter (E) in time; the suction power will be reduced if the container
is full or if the filter is clogged.
- Press the release button of the dust container (C). Tilt the container and remove it from its housing (Fig 7).
- Remove the filter holder (D) from the dust container (Fig 8). Remove the Hepa filter (E) from the filter holder
(Fig 9). Clean the filter holder and the filter with water.
warning
Rinse the Hepa filter only with clean water without using soaps or detergents.
- Empty the dust container (B) in a plastic bag and wash it with water.
- Allow to dry all components and reassemble them.
) for cleaning hard surfaces such as floors (Fig. 5). Press the
) for the cleaning soft surfaces such as carpets (Fig. 6).
9