Kenwood KAC-X1R Mode D'emploi page 4

Connection
2WARNING
To prevent fire caused by a short in the wiring,
connect a fusible link or breaker nearby the
battery's positive terminal.
2CAUTION
• If sound is not output normally, immediately
turn power off and check connections.
• Be sure to turn the power off before changing
the setting of any switch.
• If the fuse blows, check wires for shorts, then
replace the fuse with one of the same rating.
• Check that no unconnected wires or
connectors are touching the car body. Do
not remove caps from unconnected wires or
connectors to prevent short circuits.
• Connect the speaker wires to appropriate
speaker connectors separately. Sharing the
negative wire of the speaker or grounding
speaker wires to the metal body of the car can
cause this unit to fail.
• After installation, check that the brake lamps,
winkers, and wipers work properly.
* Commercially available parts
About the Lead Terminals
1
Wire Thicknesses
You can use wires with the following thicknesses:
Battery wire and ground wire
Power control wire and speaker wire
2
Strip the wire
Make a cut in the wire sheath (insulator made from vinyl, etc.) at
the position 7-10 mm away from the end of the wire, and then
remove the unnecessary portion of the sheath by twisting it.
3
Install the wire
Loosen the screw using the supplied hexagon wrench.
Insert the conductor of the wire in the terminal hole, and then
tighten the screw.
■ Remote cable connection ( Accessory of KAC-PS1D. Optional accessory for KAC-X1R.)
2CAUTION
• Before connecting the remote controller
cables, always turn the Bass boost level knob
all the way to the left.
4 English
Battery wire*
Protective Fuse*
Ground wire*
Battery
AWG 4 – AWG 8
AWG 6 – AWG 18
CENTER UNIT
(CD receiver, etc.)
Power control wire
SPEAKER OUTPUT
FUSE (25A 3) POWER IN
7 – 10 mm
(9/32" – 3/8")
SPEAKER OUTPUT
FUSE (25A 3) POWER IN
RCA cable*
LINE OUT FILTER
OFF ON
REMOTE RESET LINE IN LINE OUT
Subwoofer (L + R)
Hexagon Wrench
(Large)
Remote cable (6.0 m : 19.7 ft)
LINE OUT FILTER
OFF ON
REMOTE RESET LINE IN LINE OUT
Left input
Right input
Hexagon Wrench
(Small)
Remote controller