Sebson GS559A Mode D'emploi page 12

Siterwell Electronics Co., Limited
No.666 Qingfeng Road, Jiangbei District,
Ningbo, Zhejiang Province, 315034 China
SEBSON
Sebastian Sonntag
Gernotstr.17
44319 Dortmund
Germany
support@sebson.de
UST-IDNr.: DE246981805
WEEE-Reg.-Nr.: DE 78960174
Manual
Thank you for choosing a product of SEBSON. Read the instructions carefully and keep them for looking up before
start-up this product. A long and failure-free operation can only be guaranteed if the installation and start-up is done
properly. Before starting up this product, please check for external damage. In case of visible external damage we
immediately dis-advise the start-up of this product! Please remove all packaging material of this product before the
first start-up an and check the content for completeness!
Intended use:
This photoelectric smoke detector detects smoke using an optical sensor. This allows even slight smouldering fires
to be detected early and warned with a loud alarm sound. This is a radio alarm that can be networked with up to 15
other radio alarms (e.g. carbon monoxide alarms or water alarms) of the same manufacturer and the same product
series via radio. As soon as this smoke alarm detects dangerous smoke particles or a temperature above 54°C, it
sends a signal to all devices that are connected to this device via radio. All networked devices then switch to alarm
mode.
Scope of delivery:
 1 Smoke alarm detector
 2 x 1,5V DC type: AA batteries
 Screws for fixing (2 pieces)
 Dowels Ø 6mm (2 pieces)
General information about the product:
Note:
Consult a specialist with regard to the installation and in particular the positioning of the device in the
intended rooms in order to ensure that the proper functioning of the smoke detector is guaranteed!
 1: TEST-button; 2: LED; 3: Speaker (see fig. 2)
This smoke alarm detector may only be used in private rooms.

 Check the unit weekly for proper function (see chapter: "Start-up")!
 The unit must be replaced after 10 years at the latest!
 The smoke alarm detector can detect a fire early by recognizing the smoke or the burning articles. The
smoke alarm detector is not suitable for preventing a fire!
 This unit also contains a heat sensor. At temperatures between 54 and 70°C, the unit sounds an alarm.
12