Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
•
Remove the base locking collar (twist
anticlockwise).
•
Position the two base shells together
and fit the power cord through the
opening.
•
Close the base by firmly tightening
the 4 provided screws.
•
Attach the base onto the bottom of
the tower fan by aligning the locking
tabs with the corresponding slots.
•
Secure it into position by twisting the
base locking collar (clockwise
direction).
OPERATION
1.
Place your fan on a flat and dry surface and plug it into a suitable mains socket.
2.
Select the desired speed setting by pushing the buttons.
There are 4 settings – 0 (off), 1 (low), 2 (medium) and 3 (high).
3.
Turn the control knob to set the timer up to 1 hour.
4.
Push the oscillation button to start the right/left movement of the fan.
5.
Turn the control knob to "0" and unplug the fan after use.
CARE AND CLEANING
Caution: Always disconnect the fan from mains socket before cleaning.
•
Use only a soft damp cloth to clean the fan.
•
Never spray the appliance with liquids or submerge it in water or other liquid.
•
Never allow water to drip into the housing.
•
Never use gasoline, paint thinner or other chemicals to clean the fan.
•
If it will not be used for a long period of time, store the fan in a dry place, in its original
box to protect it from dust and humidity.
1.
Power cord
2.
Front base
3.
Rear base
4.
Base locking collar
5
TKG VT 1036
Publicité
Table des Matières
