Inspect Final Installation - GE PSB42 Manuel D'utilisation Et Instructions D'installation

STEP 11 CONNECT POWER,
CLOSE GRILLE PANEL
• Open the grille panel.
• Plug in the power cord (if necessary) by reaching
into the opening next to the water filter. The water
filter guard will need to be removed for access
(some models). Remove the 3 screws holding it in
holding the water filter bracket and move aside. Plug
in the power cord. Secure the bracket and guard
with the original screws.
Bracket
Screws
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are
on.
• The temperature controls are preset at 37°F (3º C)
for the fresh food section and 0°F (-18º C) for the
adjustments.
STEP 12 START ICEMAKER
CAUTION
Avoid contact with the moving
parts of the ejector mechanism, or with the heating
element (located on the bottom of the icemaker) that
on the automatic ice making mechanism while the
refrigerator is plugged in.
Feeler Arm
• Slide the power switch to ON.
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the
feeler arm.
• To turn the icemaker off, slide the switch to OFF.
24
Installation Instructions
Screws
Water Filter
Guard in Front of
Electric Outlet
Access
STEP 13 INSTALL TOEKICKS
• Locate the supplied toekicks (shipped taped to the
side of the refrigerator.
• Attach the LARGER toekick to the refrigerator using
ONLY the top center hole (1).
• Attach the toekick skirt to the refrigerator using the
three lower slots (2).
1
2
• A custom toekick can be installed to match or
complement the surrounding cabinetry. Use the
supplied toekick as a template to cut the shape.

INSPECT FINAL INSTALLATION

Check door alignment. Stand back away from the
refrigerator to inspect the final installation.
• Check to be sure the handles are evenly aligned
with each other at the top. To adjust, loosen the
handle screws and slide up or down. Tighten the
screws.
• Shipping or the addition of heavy door panels may
have caused the doors to move slightly out of
alignment.
Door Out of
Alignment
shown.
Bushing
D o o r H
i n g e
C a s e H in
g e
5/16" Wrench
Raise
49-1000364 Rev. 1