Hozelock FLOWMAX COLLECT 2200 Mode D'emploi page 7

3 - TECHNICAL AND PERFORMANCE SPECIFICATIONS
See performance curve (page 51)
Values are given ±10%
Electrical data
Max. flow rate
Max. pressure
Max. head
Max. immersion depth
Supply cable
Protection level
4 - DESCRIPTION (fig.1)
A - Pump body
B - Float
C - Power cable
D - Adjustable cable clamp
E - Outlet thread ¾G
F - Carry handle
G - Tap connector (supplied)
H - User manual
I - Removable base
5 - PREPARATION – USING FOR THE FIRST TIME
- Connecting the discharge hose
Screw on the tap connector (G) (fig.2).
Connect any compatible standard connector.
- Adjusting the float:
To operate correctly, the float should not be
left completely free; it should be placed in the
adjustable cable clamp. Otherwise, it is
possible that the pump would not stop if there was no
water, thus causing a risk of overheating that could
cause injury to the user.
You can adjust the float (fig.2) to vary the trigger level
to start and stop the pump (illustration fig.3) by adjus-
ting the free length of cable (pressing into the cable
clamp D).
Note: in order to ensure that the float ope-
rates correctly, at least 10 cm of cable must
be left between the base of the float plug and
the fixing on the body of the pump.
- Installation: (fig.3)
Lower the pump on a line fixed to the carry handle (F)
and position it, checking that the float has sufficient
space to move freely.
Flowmax Collect 2200
220-240V~ - 50Hz - 300W (max.)
2200 l/h (min.)
1,1 bars (min.)
11 m (min.)
7 m
H05 RNF - 10m min.
IPX8
Check that the float has sufficient space to move
freely.
- Switching on:
Ensure that nothing prevents water from being dis-
charged by the pump (e.g. kink in the pipe). Connect
the pump to the electrical supply.
The pump will start automatically once the required
water level has been reached (float in the high posi-
tion) and stops when the water level is sufficiently low
(float in low position), according to the float setting
made previously and the depth of immersion.
The pump is not intended for continuous use or for
dry running. In such a situation the pump could over-
heat and could injury the person using it.
Do not leave unattended.
7
GB