SFA Omega Lift Equipment 22050C Mode D'emploi page 5

Lubrication
A periodic coating of light lubricating oil to pivot points and hinges, and applying grease to the lift arm and wheel
fittings, will help to prevent rust and assure that wheels, casters and pump assemblies move freely. To help ensure
trouble free operation, an in-line air dryer and oiler is recommended.
Cleaning
Periodically check the pump piston and ram for signs of rust or corrosion. Clean as needed and wipe with an oily
cloth.
NOTICE: Do not use sandpaper or abrasive material on ram and pump piston surfaces.
Storage
When not in use, store the jack with saddle fully lowered.
TROUBLESHOOTING
Symptom
Jack will not lift load
Jack will lift, but not maintain
pressure
Jack will not lower after unloading
Poor lift performance
Will not lift to full extension
Possible Causes
• Release valve not tightly closed
• Overload condition
• Air pressure inadequate
• Release valve not tightly closed
• Hydraulic unit malfunction
• Reservoir overfilled
• Linkages binding
• Fluid level low
• Fluid level low
• Air trapped in system
• Fluid level low
5
Corrective Action
• Ensure release valve tightly closed
• Remedy overload condition
• Ensure adequate air pressure
• Ensure release valve tightly closed
• Discontinue use, contact Omega
technical service
• Drain fluid to proper level
• Clean and lubricate moving parts
• Ensure proper fluid level
• Ensure proper fluid level
• Follow Bleeding/Venting Trapped
Air procedure on page 3
• Ensure proper fluid level