Preparing Your Garage Door; Tools Needed; Carton Inventory; Required Accessories - LiftMaster LM3800W Mode D'emploi

Masquer les pouces Voir aussi pour LM3800W:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
5

Preparing Your Garage Door

WARNING: ALWAYS call a trained door systems technician if garage door binds, sticks, or is out of balance.
An unbalanced garage door may NOT reverse when required.NEVER try to loosen, move or adjust garage
door, door springs, cables, pulleys, brackets or their hardware, ALL of which are under EXTREME tension.
Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing and operating garage
door opener to avoid entanglement. This opener system is equipped with an unattended operation feature. The door
could move unexpectedly. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
BEFORE YOU BEGIN:
Disable locks.
Remove any ropes connected to the garage door.
Complete the following test to make sure the garage door is balanced and is not sticking or binding:
Lift the door halfway up. Release the door. If balanced, it should stay in place, supported entirely by its springs.
Raise and lower the door to check for binding or sticking.
Doors heavier than 130 kg should NOT open or fall rapidly.
If your door binds, sticks, or is out of balance, call a trained door systems technician.
6

Tools Needed

During assembly, installation and adjustment of the garage door opener, instructions will call for hand tools as illustrated below.
1.
Stepladder
2.
Drill
3.
Tape Measure
4.
Wire Cutters
5.
Pliers
6.
Drill Bits
7

Carton Inventory

If anything is missing, carefully check the packing material.
GARAGE DOOR OPENER
1.
Garage Door Opener, LM3800W
2.
Automatic Garage Door Lock, 841EU
3.
Mounting Bracket
4.
Collar with Set Screws
5.
Safety Labels
6.
4-Button Remote Control, TX4EVF
7.
MyQ Remote LED Light, 827EV
8.
Manual
REMOTE LED LIGHT HARDWARE
9.
Drywall Anchor (Screw-In) 42 mm
10.
Screw 27.85 mm
8

Required Accessories

Cable Tension Monitor 041A92642.
Infrared Photocells (for TTC or MyQ Operation: - 771EV or- 772E or- 771EVK or- G770E).
7.
Screwdriver
8.
Level
9.
Claw Hammer
10.
Sockets and Wrench with Extension
11.
Adjustable End Wrench
12.
Pencil
HARDWARE BAG
1x
11.
Screw 15 mm
1x
12.
Screw 54.8 mm
1x
13.
Handle
1x
14.
Rope
1x
15.
Screw 15 mm
2x
16.
Drywall Anchor (Screw-In) 36.8 mm
1x
17.
Screw 22 mm
2x
2x
5 / en
2x
4x
1x
1x
2x
4x
2x

Publicité

Table des Matières
loading

Table des Matières