Team kalorik TKG VT 1021 Mode D'emploi page 11

Fax +32 2 359 95 50

INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you are unsure, do
not use it and ask for qualified professional help. The packing materials (plastic bags,
polystyrene foam, nails, etc.) must be kept out the reach of children because they are
potential sources of danger. Attention: any stickers or advertising material applied to the grid
removed before using the appliance. The manufacturer declines all responsibility in case this
is not safe working practices will be respected.
 Before connecting the appliance, check that the voltage shown on the data plate matches
that of your electricity, and that the electric plug is grounded. In the event of incompatibility
between the electric outlet and the plug of the appliance, have the outlet replaced with
another more suitable type by professionally qualified personnel, who will make sure that the
section of the wires of the outlet is appropriate for the absorbed power of the heater. In
general, the use of adapters or extension cords is not recommended; if their use is
indispensable, they must conform to existing safety standards and their current capacity
(amperes) must not be less that the maximum of the heater.
 The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
 Do not place the fan on a shelf and/or near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct
the air intake grille; make sure that the front is free of unstable materials (dust, etc.).
 Make sure that the electric cord is not touching rough, hot or moving surfaces and not
twisted or wrapped around the appliance.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane
(the appliance could upset).
 Do not place the appliance near an open flame, cooking or other heating appliance.
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base and protection grid. If in doubt, have the appliance checked or
assembled by a qualified professional person. For assembly, refer to figure.
Attention: always unplug the appliance before you assemble.
1. Insert the rear grid (5) onto the motor shaft, so that the
handle is at the top (like in the figure to the side), securing it
using the 4 screws provided (4.)
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
11
Assembly page 11/29
TKG VT 1021 - 160301