Function Keys - Sunny Health & Fitness SF-E905 Manuel Du Propriétaire

FUNCTION KEYS:

1. MODE:
Press to select functions.
Press and hold the MODE button for 6 seconds to reset time,
distance and calories.
2. SET: Press to set values of time, pulse, distance and calories
when not in scan mode.
Press the MODE button to select desired functions: time, distance
or calories.
Use the SET button to set a value for time, distance or calories. The value of a function will
be set on a countdown.
Press the MODE button once more, to save the function value you've created.
3. RESET: Press to reset time, pulse, distance and calories to zero when not in scan mode.
FUNCTIONS:
1. SCAN: Press MODE button until "▼" appears at SCAN position (or until "SCAN" appears).
The meter will rotate through all 5 functions: Time, Speed, Distance, Calories and Total
Distance. Each display will be held for 6 seconds.
2. TIME: Counts the total time of the exercise from start to finish.
3. SPEED: Displays the current speed.
4. DISTANCE (DIST): Counts the distance of an exercise from start to finish.
5. CALORIES (CAL): Counts total calories burned during exercise from start to finish.
6. TOTAL DISTANCE (ODO): Counts the total distance after installing the batteries.
7. AUTO ON/OFF & AUTO START/STOP: If the wheel is in motion or any button is pressed,
the meter will become active and shall remain active. The meter will turn off automatically if
there is no motion or button pressed for 4 minutes.
8. PULSE RATE (If Available): Press MODE button until "▼" appears at PULSE position, (or
until " V " appears). In order to properly measure your pulse rate, you must place both your
palms on the contact pads located on the handlebar next to the seat. Once you have done
this, the meter will show your current heartbeat rate in beats per minute (BPM) after 3~4
seconds.
Note: During the process of "pulse measurement", the measurement value may be higher
than virtual pulse rate during the first 2~3 seconds as a result of the contact jamming.
Afterwards, it will return to normal level. To ensure testing accuracy, it is suggested that user
tests pulse during stop/pause exercise to avoid any possible influence.
The measurement value cannot be regarded as the basis of medical treatment.
9. ALARM: The functions of time, distance and calorie can be set to countdown, if any of the
above value goes to zero, the meter will alarm for 15 seconds.
Press MODE to select the function, then press SET to adjust the value.
Note:
• The meter containing only the "MODE" button does not have ALARM function.
• If you find "M" on the left side of meter screen, it is the Imperial system. The unit will be
expressed as mile.
EXERCISE METER
17