Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. If it is very hard to pedal on the higher tension levels, or you hear rubbing noises, please
remove the Belt Cover (No. 65L/R), and adjust the screw seen in the following diagram.
You will need to lower the position of the screw by turning counter-clockwise. This will
keep the Magnet Board (No. 84) from contacting the magnetic flywheel. Before
re-installing the Belt Cover (No. 65L/R), test the tension level 8 to ensure the magnets do
not touch the flywheel.
7. If you still hear noises after you did Step 5 and Step 6, please remove the Belt Cover (No.
65L/R). Loosen the screws for the Flywheel (No. 94) about a half of a rotation. See the
following diagram below.
8. If you feel the machine is uneven, please adjust the Leveler Cap (No. 5) on Real
Stabilizer (No. 3) by turning it. If the machine is wobbly when you use it, please consider
adding an exercise mat under it.
15
Publicité
Table des Matières
