Sunny Health & Fitness SF-E905 Manuel Du Propriétaire page 13

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907-8669).
If you experience any trouble with this step; please STOP and read our alternate assembly directions below
before continuing. Incorrect installation can result in permanent damage to your machine. Please try below
alternate assembly suggestion.
Step A:
Disconnect the Connecting Joint (No. 52)
from the Pedal Support Tube (No. 18L/R).
Step B:
Insert the Hinge Bolt (No. 19L/R) through the
hole of the Connecting Joint (No. 52), then
screw the Hinge Bolt (No. 19L/R) in the
Crank Arm (No. 49).
Note: Remember when assembling the left
side, you must screw counter-clockwise to
tighten. Connect the Spring Washer (No. 39)
and Nylon Nut (No. 40L/R) and attach the
Nut Cap (No. 41). You can now reattach the
Connecting Joint (No. 52) to the Pedal
Support Tube (No.18L/R).
STEP 4:
Secure the 2 Pedals (No. 27L/R) to the 2
Pedal Support
respectively using 4 Hex Bolts (No. 28), 4
Flat Washers (No. 29) and 4 Nylon Nuts
(No. 30) using Spanner (No. 105).
CAUTION:
Both pedals are labeled; L for LEFT and R
for RIGHT.
12
Tubes (No. 18L/R)