Lifting And Transporting The Machine; Practical Guide For The Operator; Controls - Description - IPCEagle CLEANTIME 90 Mode D'emploi

5.7.

Lifting and transporting the machine

All phases must be performed in an adequately lit room and adopting the safety
The operator must always use personal protection devices.
To load the machine onto a means of transport, proceed as follows:
• empty the dirty water drum and detergent tank;
• R models with rollers: empty the debris bin (fig. 17).
• remove the squeegee and brushes (drive disks or rollers);
• remove the batteries (in battery models);
• place the machine on the pallet and fix it with plastic straps or metal brackets;
• lift the pallet (with the machine) using a fork lift truck and load it onto the means of
transport;
• anchor the machine to the means of transport with cables connected to the pallet and
machine itself.
6.1.

Controls - Description

With reference to fig. 6, the machine has the following controls and indicator lights:
•
Power on light (fig. 6, ref. 1 - cable model only): green, indicates that the power
cable of the machine is connected to the mains.
• Battery charge light (fig. 6, ref. 1 – battery model only): 3 LEDs (red, yellow and
green) indicate the battery charge level. There may be:
a) green LED on: batteries 100% to 50% charged;
b) yellow LED on: batteries 50% to 18% charged;
c) red LED on: batteries almost flat.
d) red LED flashing: batteries completely flat; after a few seconds the brushes
stop and the brush switch light also comes on.
•
Main key switch - emergency button (fig. 6, ref. 15 BT models with electric
drive): enables and disables power to all machine functions. Acts as a safety device.
To start up the machine, turn the key clockwise. To stop the machine press the
button.
•
Main Switch (fig. 6, ref. 3 B models with mechanical drive): enables and disables
electrical power to all machine functions. To start the machine press the button. To
stop the machine press the button.
• Brush button with light (fig. 6, ref. 3 - all models): enables (LED on) and disables
(LED off) brush and suction motor operation.
o CT40, BT60 ECS, CT70 ECS: as well as enabling brush operation, pressing
this button automatically attaches the brushes.
o CT40 BT50-60 ECS - CT70 ECS model, holding this button down for at least 5
seconds also selects the type of machine operation, "MICROFIBRE" with
microfibre disk or "BRUSH-PAD" with brush/abrasive disk.
• Suction button with light (fig. 6, ref. 2): switches the suction motor responsible for
drying the floor being washed on ("LED on") or off ("LED off"). The light is on when
there is power to the suction motor.
• Tap lever (fig. 6, ref. 6 - 230-110-115VAC mains electricity powered models only):
provides continuous control of the flow of detergent to the brushes. Pull up to increase
the liquid outflow.
ENGLISH
12
IMPORTANT
measures most appropriate to the situation.
6.

PRACTICAL GUIDE FOR THE OPERATOR