Telefunken TECHCLIM9 Mode D'emploi page 46

2. Remote control
The remote control allow you to select your program away from your appliance. It works with 2 batteries
type AAA/LR03 - 1.5V.
Inserting the batteries: Press the plastic flap cautiously at the back of the remote control and lift up the lid.
Insert the 2 batteries according to the polarities shown inside the location. Close the plastic flap.
Note: Handle the remote control carefully. It should neither fall nor be exposed to sunlight or other heat
source. Please note the ambient temperature is displayed on the control panel.
▪ To stop the appliance: press on the ON/OFF button.
▪ Unplug your appliance.
▪ Empty the water tank during long period of non-used.
The appliance has a safety compressor device. If the appliance turns itself off and does not switch itself on
again, disconnect it from the mains supply, and wait for approximately 3 minutes before reconnecting.
WARNING: Unplug the appliance during cleaning. Do not put anything on the
appliance, such as clothing or towels. Do not use the appliance in the bathroom or other
wet areas.
Timer setting:
You can set the delay stop time and delay start time when the unit is
turned on or off. When the unit is turned on, press the timer button. The
indicator light switches on and flashes. Press one UP or DOWN button to
set the timer time between 30 minutes and 24 hours. Up to 10 hours, the
time is adjustable in increments of half an hour. From 10 hours, it is in
increments of one hour. Then press the timer button to confirm the
setting.
For delay strop time: Once the time is up, the unit turns off automatically.
For delay start time: Once the countdown time has elapsed, the unit starts
automatically in the selected mode.
When the countdown time has elapsed, the unit starts automatically in
the selected mode.
You can change or cancel your setting by pressing this button again.
If you do not need to set the delay start, press the TIMER button again to
exit this setting. After 5 seconds, the setting will be automatically changed
and the display will return to the previous temperature. If you want to
check the remaining time, press the timer key. The delayed start
automatically selects the fan mode, temperature, and speed, according
to the settings you made last time. To activate the timer function when
the unit is off, press the timer button to set the delay start time, then a
second time to set the delay stop time, using the same procedure as
above.
8
ENGLISH