Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Push the tab in the direction of the arrow as shown in Fig. 1 below and move the lid upwards at the
same time. Remove the battery from its housing and replace it with a new one. Before using the
remote control, remove the transparent safety label shown in the figure.
Note : When the timer of the appliance is active, the point on the right of the screen flashes. 1L , 2L ...:
Indicates the power level of the heater. 1H, 2H ...: Heater timer display (May be programmed up to 9
hours. )
Er1: Overheating.
Function Key
: Controls the temperature level setting and the timer setting of the heater.
Temperature level shall be increased one level for each press on the key. Keep this key pressed for 6
seconds to perform a timer setting. Select the desired time zone from the menu displayed on the screen.
Appliance Stand-by
displayed on the screen.
This key is used for switching the appliance on and off.
Used increasing the level, temperature and timer settings.
Used decreasing the level, temperature and timer settings.
Heater level setting: Heater switches to power control mode. Allows
level setting between 3 levels using the + and - keys. Displays L1, L2,
L3,L4 by signalling for 0.2 seconds at each step. If the heater is in power
control mode, appliance operates at maximum level when the max
button is pressed.
*Step L4 applies only to 2500 W heaters.
Thermostat switch: Switches to temperature setting mode. Performs
temperature setting from 10 to 40 degrees with the + and - keys. Press
mode button to save the set temperature. User is required to press this
button once only to see the set temperature. Signals for 0.3 seconds at
each step.
Timer key: Switches to timer mode by flashing on the display, and timing
may be set up to 9 hours with the + and - keys. Press this key again to
save the timing after setting it. User is required to press this button once
only to see the remaining time. 1H, 9H are displayed on the screen.
: Indicates that the appliance is ready for operation when this symbol is
10
24
Publicité
Table des Matières
