Table des Matières
Publicité
SWITCH TO NEXT DAY'S WEATHER INFORMATION
For each press of the UP [▲] button, the user can switch and view the weather information
from today to tomorrow, one-day-after and two-day-after.
Today's weather
information:
UP [▲]
Tomorrow's weather
information:
UP [▲]
UP [▲]
One-day-after's
weather information:
UP [▲]
Two-day-after's
weather information:
[DAY/NIGHT]
flashing
WEATHER
flashing
WEATHER
WEATHER
DATE
WEEKDAY ALARM
SINGLE ALARM
PRE-ALARM.
[DAY/NIGHT]
WEATHER STATUS
There are total 15 weather status for Day and 15 weather status for Night.
[DAY/NIGHT]
DAY/NIGHT
REMOTE SENSORS STATUS
The wave icon above the current channel icon shows the connection status of the corresponding
remote sensor:
Icon
Status
Searching for the signals from the remote sensor
Corresponding remote sensor signal received successfully
No signals received for over 1 hour
SEARCH FOR REMOTE SENSORS
- The main unit can be manually activated to search for the signals from remote sensors by
pressing and holding DOWN (▼) button.
VIEWING REMOTE (CHANNEL) TEMPERATURE AND HUMIDITY
Static Display:
- Press [ CHANNEL ] keys to select measurements from different remote sensors, each is
mode to a unique channel 1,2, or 3
Channel Auto-Scan Display:
- Press To enable an automatic scan of all channels, press and hold [CHANNEL], until the
icon is displayed. The measurements from each remote channel will be alternately displayed
with a 5 seconds viewing.
NOTE: the channel auto-scan feature can be actived only if there are more than one remote
sensors operating and are set to different channels.
MAXIMUM AND MINIMUM TEMPERATURES
- The maximum and minimum recorded indoor and outdoor temperatures and humidity will be
automatically stored in the memory of the main unit. To display them, press [MEM] button
and the respective indicators, [MAX] or [MIN] will be displayed.
- To clear the memory, hold [MEM] button for 3 seconds. The maximum and minimum
temperature records will be erased.
61
Publicité
Table des Matières
