Frico WattsTemp 860 Guide D'utilisation page 23

hour programmed following your weekly program.
This automatic control system works in the following
way:
When you start your thermostat for the first time, it will
measure the time taken by your installation to reach
the set temperature. The thermostat will re-measure
this time at each program change to compensate
external temperature change & influence. You can now
program your thermostat without the need to adjust the
temperature in advance because your thermostat does
it automatically for you.
st
.H First Heat (for cement, concrete floor...)
1
09
This function is generally used just after the installation
to prevent your floor against first heating damages.
This first heat function works in the following way:
2 working hours dispatched in 24 hours the 1rst day
and 1H00 more the following days, during 21 days.
During this period the floor temperature (or room if no
floor sensor wired) is limited to 20°C
Clr ALL: Factory setting
10
Press and maintain (Ok) key during 10s to reset Set
points temperatures and user parameters in this menu
to factory default settings. User programs will also be
resetted.
* Pay attention:
Ensure you that you have all necessary elements to re-
setup your installation before to use this function.
Software version
11
__._ 860V
End: Exit the parameter‟s menu
12
Press (OK) key to exit installation parameter menu and
return to normal operation.
* Note:
Your thermostat has other functions available (floor limitation).
Contact your installer or wholesaler for more explanation.
23