Frico WattsTemp 860 Guide D'utilisation page 22

Yes the automatic change over time between Summer
and Winter is activated according to date
No no daylight summer time automatic change.
Airc: Calibration of the internal probe
05
The calibration must be done after 1 day working with
the same setting temperature in accordance with the
following description:
Put a thermometer in the room at 1.5M distance from
the floor (like the thermostat) and check the real
temperature in the room after 1 hour.
When you enter on the calibration parameter "no" is
displayed on the right to indicate no calibration has
made.
To enter the value shown on the thermometer, use the
(-) or (+) keys to enter the real value.
Then, press (Ok) to confirm.
The message "Yes" should be displayed, the value will
be stored in the internal memory.
If you need to erase a calibration press on the escape
key (
The old value will be erased and the message "no" will
be displayed.
* Pay attention:
Only the heating element managed by the thermostat
must be used during the complete step of the
calibration.
Amb.c: Calibration of the external ambient probe
06
The calibration must be done same as described above
if the external sensor is connected and used like an
external ambiance sensor.
flr.c: Calibration of the floor probe
If the external sensor is used as floor sensor, the
thermometer should be put on the floor.
out.c: Calibration of the external ambient probe
If the external sensor is used to view the outside
sensor use an outside thermometer to calibrate the
sensor.
*This parameter is only available if the external probe is
connected
AFrz: Anti Freeze temperature:
07
This Anti-freeze temperature used in Holiday mode.
Adjustable 0.5 to 10.0°C with default value 7.0°C.
ITCS:
08
The Intelligent Temperature Control System will
activate your installation in advance (2 hours
maximum) to assure the desired temperature at the
).
22