MSI X470 GAMING PLUS Présentation Rapide page 44

fCPU Power Duty Control [Thermal Balance]
Sets the current of every VRM phase and the thermal conditions of every phase
component.
[Thermal Balance] Maintains the VRM thermal balance.
[Current Balance] Maintains the current VRM balance.
fCPU NB Loadline Calibration Control [Auto]
The CPU-NB voltage will decrease proportionally according to CPU-NB loading.
Higher load-line calibration could get higher voltage and good overclocking
performance, but increase the temperature. If set to Auto, BIOS will configure this
setting automatically.
fCPU NB Over Current Protection [Auto]
Sets the current limit for CPU-NB over-current protection. If set to Auto, BIOS will
configure this setting 0utomatically.
[Auto]
[Enhanced]
fCPU NB Switching Frequency [Auto]
Sets the PWM working speed to stabilize CPU-NB voltage and minimize ripple
range. Increasing the PWM working speed will cause higher temperature of
MOSFET. So please make sure a cooling solution is well-prepared for MOSFET
before you increase the value. If set to Auto, BIOS will configure this setting
automatically.
fCPU NB Power Duty Control [Thermal Balance]
Sets the current of CPU-NB VRM phase and the thermal conditions of every phase
component.
[Thermal Balance] Maintains the VRM thermal balance.
[Current Balance] Maintains the current VRM balance.
fVR 12VIN OCP Expander [Auto]
Expands the limitation of VR Over Current Protection with 12V input voltage. The
higher expanding value indicates less protection. Therefore, please adjust the
current carefully if needed, or it may damage the CPU/ VR MOS. If set to "Auto",
BIOS will configure this setting automatically.
f CPU Voltages control [Auto]
These options allows you to set the voltages related to CPU. If set to Auto, BIOS will
set these voltages automatically or you can set it manually.
f DRAM Voltages control [Auto]
These options allows you to set the voltages related to memory. If set to Auto, BIOS
will set these voltages automatically or you can set it manually.
f Memory Changed Detect [Enabled]*
Enables or disables the system to issue a warning message during boot when the
memory has been replaced.
[Enabled] The system will issue a warning message during boot and then you have
to load the default settings for new devices.
[Disabled] Disables this function and keeps the current BIOS settings.
f CPU Specifications
32
BIOS Setup
This setting will be configured automatically by BIOS.
Extends the current range for over-current protection.