Troubleshooting - Klarstein VIENNA Mode D'emploi

EN
24

TROUBLESHOOTING

Safety Cut-Out device
To ensure against the potential hazard caused by blockage of the air outlet, this
unit is equipped with an automatic overtemperature safety cut-out device. When the
device is activated the heater will not operate. If this occurs, the unit can be reset using
the following procedure:
1. Turn the fire off by depressing the on/off switch on the unit.
2. Unplug the power cord form the electrical mains supply socket and leave it
disconnected for at least 15 minutes.
3. Ensure that the air vents are free from obstruction.
4. Plug the power cord back in to the mains socket.
5. Turn the fire back on.
6. If the fire fails to operate, check the fuse in the plug.
7. If the fuse in the plug is OK and the fire is still not functioning, contact a qualified
service person.
Problem
Stove turns off and-
will not turn on.
.
Flame is not moving.
Cause
Stove has overheated Reset switch by
and safety device has turning main power
caused thermal switch switch off and wait-
to disconnect or home ing 5 minutes then
circuit breaker has turning it back on.
opened.
Flame motor Call a qualified
defective. service technician to
replace flame motor.
Check