MIGHTY SEVEN QG-102 Mode D'emploi page 3

Warning:
1. This tool should only be used as a hand operated tool. It is powered by compressed air and is not insulated
against electric shock.
2. This tool is specifically designed for cutting sheet metal. Any application or use of this tool other than what it is
designed for is strictly prohibited.
3. This tool is available for cutting 1.2mm general sheet steel and 1mm sheet stainless steel.
4. High sound levels may cause hearing damage. Always wear hearing protection when operating this tool.
5. Wearing eye/face protection can reduce the danger of high-speed materials being emitted from the tool.
6. User must wear proper clothing. Loose clothing, long hair, stings, straps, belts and jewelry should not be worn
when operating this tool.
7. Always wear gloves to reduce the risk of cuts or burns.
8. Ensure that the work piece is supported or fixed properly before operating
9. Always turn off the air supply and disconnect the air hose before changing, replacing or making adjustments
on this tool.
10. Make sure there is no gas or combustible material stored near the tool when servicing, changing insert tools,
or storage.
11. Release the throttle trigger to avoid danger if there is a failure of energy supply and when connecting or
disconnecting the air hose.
12. Rest the guide plate firmly on the work piece while operating, if necessary.
13. Beware if the compressed air hose breaks unexpectedly, or is being connected or disconnected improperly.
This whipping action may cause injury.
14. Prolonged use will cause user fatigue. Periodic breaks are recommended for user safety.
15. It is recommended to stop operating the tool whenever the user experiences discomfort, tingling or pain
during use.
16. Always use caution when operating the tool to prevent injury.
17. Avoid storing this tool where it is subject to high humidity.
3