Uline VACMASTER H-9461 Manuel D'utilisation page 10

INSTALLING FOAM WET FILTER
1. Verify that the power cord is
disconnected from the outlet.
(See Figure 46)
2. Remove power head and place
in upside down position. Follow
instructions to remove cartridge
filter.
3. Carefully slide foam wet filter
down over the filter cage,
ensuring the cage is completely
covered. (See Figures 47-48)
WARNING! To reduce the risk of electric shock, unplug before troubleshooting.
OPERATING ISSUE
Vacuum will not
operate.
Dust comes out from
motor cover.
Reduced efficiency,
speed and/or motor
vibration.
PAGE 10 OF 30
INSTALLING AND CLEANING FOAM WET FILTER
Figure 46
Figure 47
Figure 48
TROUBLESHOOTING
CAUSES
No power supply.
Faulty power cord.
Collection tank is full.
The cartridge filter is missing or
damaged.
There is a blockage in the nozzle,
hose or collection tank inlet.
The cartridge filter is clogged by
fine dust.
CLEANING FOAM WET FILTER
1. With the removed power head
in an upside down position,
carefully remove foam wet filter.
(See Figure 49)
2. Use a mild soap and water
solution to wash foam wet filter
and rinse with clean water.
(See Figure 50)
3. Allow filter to air dry before
installing and using again.
Check power supply: cord, breakers and fuses.
Unplug and check the power cord. If
damaged, have it repaired by a professional.
Empty collection tank.
Attach or replace cartridge filter.
Check nozzle, hose and collection tank inlet for
blockage.
Remove the filter and clean it, or install a new
cartridge filter.
1-800-295-5510
uline.com
Figure 49
Figure 50
RECOMMENDATIONS
0821 IH-9461