FAR R5315W Manuel D'utilisation page 19

ENGLISH
4. The disassembly and installation of bottom parts :
A. Disassemble lower hinge and screws. Then install them on the other side and
consolidate the lower hinge.
Note: the refrigerator-freezer incline angle less 45°.
B. Swap over the position of the adjustable foot to the other side of the cabinet.
C. Swap over the position of the lower door block to the other side. Install the
screws and consolidate them.
5. Install the lower door and take care of its alignment with the appliance body.
6. Tighten the screws of the middle hinge on the reversible side.
7. Install the top door and remove the existing top door block. Install a new top door
block (not the same one) on the reversible side. Screw it down.
GB-12
8. Move the hinge to another side of the box after removing the screws on the hinge;
Use screws to fasten.
9. Install the hinge cover after fastening the hinge.
ATTACHEMENT
1. Components that could be transferred from one side to the other directly after
disassembling are listed below:
– top door top endcap coverslip (2pcs)
– top cover buckle (1pc)
– hinge shaft sleeve (1 or 2pcs)
– screws of top hinge (3 pcs)
– middle hinge assembly (1 pc)
– screws of middle hinge (2 pcs)
– insert nail (2 pcs)
– screw cap (2 pcs)
– door stopper (1 pc)
– bottom hinge assembly (1 pc)
– screws of lower hinge (3pcs)
2. The component that could be swapped over from one side to the other only after
reconstruction is listed below:
– top hinge assembly
ENGLISH
GB-13