Table des Matières
Publicité
-
WARNING : These operations must be perfomed by a qualified technician.
-
If the appliances is connected to liquid gas, the regulation screw must be fastned as tightly as
possible.
-
When gas cylinder is adopted, the gas cylinder or gas container must be properly settled (vertical
orientation).
-
Use only flexible or rigid metal hose for gas connection.
-
IMPORTANT : If a staineless steel hose is used, it must be installed so as not touch any mobile part
of the furniture (e.g.drawer). It must pass thorugh an area where there are no obstructions and where
it is possible to inspect it on all its length.
-
After connection to the gas supply, check for leaks with soapy water. Light up the burners and turn
the knobs from max position 1* to minimum position 2* to check flame stability.
ELECTRICAL WARNINGS
-
Make sure the voltage specified on the rating plate corresponds to that of your home.
-
For installation to comply with current safety regulations, an omnipolar switch with minimum contact
gap of 3mm is required.
-
Regulation require that the appliance is earthed.
-
For appliances with fitted plug, if the plug is not suitable for you socket outlet, contact a qualified
technician.
-
Do not use extension leads, multiple sockets or adapters. Do not connect the appliance to a socket
which can be operated by remote control.
-
The power cable must be long enough for connecting the appliance, once fitted in its housing, to the
main power supply.
-
Do not pull the power supply cable.
-
If the power cable is damaged it must be replaced with an identical one. The power cable must only
be replaced by a qualified technician in compliance with the manufacturer instruction and current
safety regulations. Contact an authorized service center.
-
Do not operate this appliance if it has a damaged mains cord or plug, if it is not working properly, or if
it has been damaged or dropped. Do not immerse the mains cord or plug in water. Keep the cord
away from hot surfaces.
-
The electrical components must not be accessible to the user after installation.
-
Do not touch the appliance with any wet part of the body and do not operate it when barefoot.
-
It must be possible to disconnect the appliance from the power supply by unplugging it if plug is
accessible, or by means of an accessible multi-pole switch installed upstream of the socket in
conformity with national electrical safety standards.
-
The rating plate is on the front edge of the oven (visible when the door is open).
CORRECT USE
CAUTION : The cooking process has to be supervised. A short cooking process has to be
supervised continuously.
-
Do not use the hob as a work surface or support.
WARNING : Unattended cooking on a hob with fat or oil can be dangerous and may result in fire.
Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a
lid or a fire blanket.
-
Use oven gloves to remove pans and accessories, taking care not to touch the heating elements.
-
IMPORTANT : Should you experience difficulty in turning the burners knobs, please contact After
Sales Service for replacement of the burner tap if found to be faulty.
-
The openings use for the ventilation and dispersion of heat must never be covered.
-
Use pots and pans with bottoms the same width as that of the burners or slightly larger (see specific
table). Make sure pots on the grates do not protrude beyond the edge of the hob.
-
WARNING : Do not let the burner flame extend beyond the edge of the pan
-
IMPORTANT : Improper use of the grids can result in damage to the hob: do not position the grids
upside down or slide them across the hob.
-
Do not use : Cast iron griddles, ollar stones, terracotta pots and pans.
-
Heat diffusers such as metal mesh, or any other types.
GB
5
Publicité
Table des Matières
