ratiotec rapidcount X 500 Manuel De L'utilisateur page 6

[EN]
10. BAT: ____________
11. TOP ARROW: ___
12. BOTTOM ARROW: _ Long press of button: Select collection stacker (Report RC).
13. TIME SETTING: ___
Setting
1. Press the CURR button for three seconds to call up the user menu.
2. Press the ARROW buttons to navigate the menu. Then you can confirm the setting with the CURR button.
3. After the adjustment is completed, press the CLEAR button to exit the menu.
Operation
Connect the mains cable and switch the device on. The device will now run a self-test. After the test is successfully
completed, the device is ready for use. If error messages occur, refer to pages 8-9 of the user manual for an overview
of the error messages with solution.
Fan the banknotes slightly and place the stack of banknotes to be counted in the middle of the banknote feeder.
6
The batch function allows you to count an exact number of banknotes as a bundle,
e.g. 10 notes from a larger stack of banknotes. The batch counting of the banknotes
can be set independently of the counting mode. The device stops the counting
procedure automatically, as soon as the preset batch has been reached.
Value Batch (VAL BAT): In order to set a value batch yourself, press MODE and select
the function VAL BAT. Enter the value batch required from 1 to 99999 using the
keypad buttons 0-9.
Long press of button: Select reject stacker (Report RJ).
Press the CURR button for three seconds in order to call up the user menu and to set
the time.