Appendix A: Upgrading The Firmware In Your Mount And Hand Control - Celestron CGX-L Mode D'emploi

Appendix A:
Upgrading the Firmware in Your Mount
and Hand Control
Setup overview (Figure 12 1 and 12 2)
To check for new firmware updates, refer to this URL:
http://software celestron com/updates/CFM/CFM/
1 Plug your NexStar+ hand control into the AUX1 or
AUX2 port
2 Plug a USB mini cable from your PC to your hand control
3 Plug power into the CGX-L and power it on
4 Open Celestron Firmware Manager (CFM)
5 CFM will check your hardware and scan for updates
CFM will automatically determine which components
will require updating
6 Proceed to click "Update" in CFM and allow updates
to complete
Figure 12.1 Updating Mount and Hand Control Firmware
Figure 12.2 Updating Hand Control Firmware
NexStar+
Hand Control
User Supplied
Mini USB Cable
NexStar+
Hand Control
User Supplied
Mini USB Cable
Items needed:
1 PC with CFM installed
2 Mini USB cable (Not included)
3 Included NexStar+ Hand Control
4 12VDC 3A power for the mount
Aux Port
12VDC 3A
Power Supply
Items needed:
1 PC with CFM installed
2 Mini USB cable (Not included)
3 Included NexStar+ Hand Control
* No additional power is required!
ENGLISH | 25