Victron energy EasySolar-II 48/3000/35-32 230V MPPT 250/70 GX Manuel page 135

APPENDIX A: Connection overview
BIJLAGE A: Overzicht aansluitingen
ANNEXE A : Vue d'ensemble des connections
ANHANG A: Übersicht Anschlüsse
APÉNDICE A: Conexiones generales
APPENDIX A: Anslutningsöversikt
APPENDICE A: Panoramica dei collegamenti
EN:
A Load connection. AC-OUT-1 Left to right:N (neutral), PE (earth/ground), L (phase)
B Load connection. AC-OUT-2 Left to right: N (neutral), PE (earth/ground), L (phase)
C AC input. AC-IN Left to right: N (neutral), PE (earth/ground), L (phase)
D Alarm contact: left to right NO, NC, COM.
E Start without Assistants: Press and hold this button when starting
F Primary ground connection M6 (PE)
G M8 battery positive connection
H M8 battery minus connection
I Switch: -:On, 0:Off, =:charger only
J Terminals top to bottom:
1. 12V 100mA
2. Programmable contact K1 open collector 70V 100mA
3. External ground relay +
4. External ground relay –
5. Aux input 1 +
6. Aux input 1 –
7. Aux input 2 +
8. Aux input 2 –
9. Temperature sense +
10. Temperature sense –
11. Battery voltage sense +
12. Battery voltage sense -
K External current sensor
L 2x RJ45 VE-BUS connector for remote control and/or parallel / three-phase operation
M Connector for remote switch: Short to switch "on".
N Dedicated BMS-Can port (VE.Can not supported)
O USB
P Reset Button: What is the reset button used for? MCO
Q Ethernet Port
R VE.Direct Port
S Solar Positive M6 Bolt
T Solar Negative M6 Bolt