Intended Use; Included In The Delivery; Safety Instructions - Conrad 75 15 98 Mode D'emploi

O P E R A T I N G I N S T R U C T I O N S
1/3" CCD Colour Camera,
420TVL, 4-9 mm, IR
Item-No. 75 15 98

Intended Use

This colour camera with 36 IR-LEDs is intended for the visual surveillance and protection
of critical, obscured areas (e.g. parking lot surveillance).
The camera is suitable for operation in outdoor areas (IP65). The voltage is supplied via
12 V/DC (suitable power transformer is available as an option).
With an IR rang of up to 40 metres (depending on the ambient conditions) in darkness, and
a horizontal detection angle of 90°, the camera, for example, is very suitable for parking lot
surveillance.
At the back of the camera, the ZOOM and FOCUS can be adjusted manually.
The camera's integrated infrared LEDs allow night vision. Please note that coloured image
reproduction changes into black and white monochrome when increasing darkness acti-
vates the IR-LEDs. The brightness is detected by the camera using a photo sensor on
the front.
Please bear in mind that it is prohibited by law to observe strangers with a camera without
their knowledge and consent.
Operating the product in any other way than described above is not permitted and may lead
to damage to the product, which can give rise to risks such as short circuit, fire and elec-
tric shock. The product must not be modified or converted. Always observe the safety
instructions included in these operating instructions. Read the operating instructions care-
fully and keep them for later reference.

Included in the delivery

• Camera
• Mounting bracket
• Installation material
• Drilling template
• Mounting tool
• Operating Instructions
Symbols
A lightning-bolt symbol in a triangle indicates a health hazard, e.g. dan-
ger of electric shock.
The exclamation mark in a triangle indicates a particular risk during han-
dling, operation and control.
The "Hand" symbol indicates special tips and operating information.

Safety Instructions

The warranty will be void in the event of damage caused by failure to
observe these safety instructions! We do not assume any liability for any
resulting damage!
We do not accept liability for damage to property or persons caused by
improper use or as a consequence of ignoring the safety instructions!
The warranty will be void in such cases.
• The camera must not be modified or converted, as not only the CE
approval will become void but also the warranty.
• The Camera's's integrated infrared LEDs allow night vision. Please
note that coloured image reproduction changes into black and white
monochrome when increasing darkness activates the IR-LEDs. The
brightness is detected by the camera using a photo sensor on the front.
• The camera should not be exposed to extreme temperatures, direct
sunlight, intense vibrations or heavy mechanical stress.
• If the device is used with other devices e.g. a television screen, the
operating instructions and safety notices for the connected devices
must be followed.
• The use of the surveillance camera system does not replace the per-
sonal supervision of children, or people who require special assis-
tance, but only serves as a support to this supervision.
• After rapid changes in temperature, the camera requires some time to
stabilise, in order to adjust to the surrounding temperature, before it
can be used.
www.conrad.com
Version 08/09
°
• Electronic devices are not toys and should be kept out of the reach of
children!
• Please contact a qualified person if you are unsure about the safety and
correct use of the system components.
• Never leave the packaging material lie around unattended. Plastic
film/bags etc. can be dangerous playthings for children, there is a risk
of suffocation.
• If you have reason to assume that safe operation is no longer possible,
disconnect the device immediately and secure it against inadvertent
operation.
• It can be assumed that safe operation is no longer possible if:
- the device is visibly damaged,
- the device no longer works and
- the unit was stored under unfavourable conditions for a long period
of time or
- it has been subjected to considerable stress in transit
• In commercial institutions, the accident prevention regulations of the
Employer's Liability Insurance Association for Electrical Systems and
Operating Materials are to be observed.
• The camera is suitable for operation in outdoor areas (IP65).
• The voltage is supplied via 12 V/DC (suitable power supply unit is avail-
able as an option).
• Ensure that all the electrical connections and connecting cables
between the devices, and any extension cables, conform to the regula-
tions and comply with the operating instructions.
• Live components may be exposed, if the covers are opened or parts
removed (unless this can be done without tools). Connection points
may also be live. If the appliance needs to be opened for calibration,
servicing, repair or to replace parts or circuit boards, it must be dis-
connected first from all sources of current . If servicing or internal
repairs are necessary, this must be carried out by a specialist who is
familiar with the risks involved and with the relevant regulations.
• Capacitors in the device may still be charged, even if the device has
been disconnected from all power supplies.
• When installing / mounting the appliance, make sure that the connec-
tion cable is neither pinched nor damaged by sharp edges.
• Disconnect the camera from the power supply, if the camera is not
used for longer periods of time.
• Disconnect the camera from the power supply before cleaning.
• For safety reasons, disconnect the camera from the power supply dur-
ing thunderstorms.
• Never replace damaged mains cables yourself. In such an event, dis-
connect the appliance from the mains and take it to a specialist work-
shop.
• Never pour fluids above electrical devices. You run the risk of causing
a fire or a fatal electric shock. If liquids enter the device, immediately
disconnect it from the power supply, remove the plug from the mains
and consult an expert.
• Maintenance, adjustment and repair may only be carried out by a qual-
ified specialist or a specialised repair shop.
• If you have any questions, which are not answered in this manual,
please contact our technical service or another specialist.