Preparation; Attire; Pre-Start - Mi-T-M Corporation HGM Serie Mode D'emploi

DANGER
risK of eXplosion or
SMELL FOR GAS BEFORE
STARTING UNIT. ALWAYS SNIFF
AREA AROUND THE MACHINE
FOR A GAS SMELL. BE SURE TO
SNIFF FLOOR AREA, SINCE SOME
GAS IS HEAVIER THAN AIR AND
WILL SETTLE ON THE FLOOR.
if you smell gas:
•
DO NOT START UNIT.
•
DO NOT OPERATE ANY
ELECTRICAL SWITCH.
•
D O N O T L I G H T
APPLIANCE.
•
DO NOT USE ANY PHONE IN
THE ROOM OR AREA.
•
L E A V E , G O
ANOTHER LOCATION AND
USE A PHONE TO
YOUR GAS SUPPLIER.
•
FOLLOW THE GAS SUPPLIER'S
INSTRUCTIONS.
•
IF YOU CANNOT REACH YOUR
GAS SUPPLIER, CALL THE FIRE
DEPARTMENT.
6

attire:

Proper attire is essential to your safety. It is advised to utilize whatever means
necessary to protect eyes, ears, and skin. Additional safety attire (such as
respiratory mask) may be required when using detergent cleaning agents with
this heater module.

pre-start:

. Before lighting, smell all around the machine for gas. Especially, sniff the
floor area because some gas is heavier than air and will settle on the
floor. Do not operate unit if smell exists. Leave the location and contact
a qualified serviceman.
2. Check to ensure the voltage is on.
pre-start inspection procedures:
. Before starting the unit, perform the following procedures:
a. Check for gas smell. If a gas smell is detected, DO NOT START UNIT!
A N Y
See "Risk of Explosion or Fire" warnings, pg. 4.
b. Check all hose connections to ensure they are securely tightened.
c. Inspect for system water and oil leaks.
d. Inspect high pressure hoses for kinking, cuts and leaks. If a cut or leak
T O
is found, DO NOT USE HOSE! Replace hose before starting unit. See
"Risk of Injection" warnings, pg. 7. Be sure that all damaged parts are
CALL
replaced and that the mechanical problems are corrected prior to opera-
tion of the unit. If you require service, contact your Customer Service
Representative.

preparation

HGM-SERIES Hot Water Heater module Operator's Manual