Water Supply; Hose Connection; High Pressure Connection - Mi-T-M Corporation HGM Serie Mode D'emploi

water supply:

. Using the quick connect at the inlet of the unit, connect the water supply
to the unit. For best results, the input to the unit should be 3-6 GPM on
3506, 5-8 GPM on 3508 and 7-0 GPM on 200.
NOTE: Incoming water pressure must not exceed 3500 PSI on 3506 and
3508, and 2000 PSI on 200.
2. Connect the discharge hose provided to the outlet of the unit.
3. Connect gun/wand/lance assembly to the discharge hose.
4. Make sure all connections are secured before start-up.

HigH pressure connection:

Connect the high pressure discharge hose by connecting one end to the
heater module and the other end to the gun assembly. Make certain the
quick connects are securely locked together.
HGM-SERIES Hot Water Heater module Operator's Manual
installation

Hose connection

HigH pressure Hose connection
QuicK connect
3