Gas Piping - Mi-T-M Corporation HGM Serie Mode D'emploi

gas piping:

1. Installation of this unit should be performed by a qualified serviceman
and all gas piping must conform to all local, state and national codes,
including the National Fuel Gas Code ANSI Z223./NFPA No. 54. In
Canada; Refer to the CSA B49. Gas Installation Code.
2. Turn off gas and electricity before starting installation or service.
3. The gas line to the burner should be a separate supply from the meter
because of the burner demand. Use new pipe and locate it with future
service in mind. Use only black pipe or tubing suitable for gas applications
and make sure the pipe is free from cutting burrs and defects. Use joint
compound (not teflon tape) only on male fittings, leaving clean the first
two threads to be engaged. DO NOT use compound on female threads
where it can be pushed into the line and cause gas valve failure.
recommended pipe siZes for gas supply line
NATURAL GAS
DISTANCE TO UNIT
FROM REGULATOR
0-50 Feet
50-00 Feet
00-200 Feet
4. Following the gas line from the meter or regulator, before the machine,
install a manual main shut-off valve.
5. Down stream from the main shut-off valve, a tee and drip leg should be
installed to catch debris and moisture. This leg must be capped.
6. A 4" nipple and gas regulator should be installed off of the tee. This
regulator should control gas pressure down to 3"-2" W.C.P.
7. On the other side of the regulator, another 4" nipple and union should
be installed.
8. After the union and before the gas valve on the unit, a manual shut-off
valve should be installed with a /8" NPT plugged tapping accessible for
test gauge connection between it and the union.
HGM-SERIES Hot Water Heater module Operator's Manual
installation
DISTANCE TO UNIT
PIPE SIZE FROM REGULATOR
-/2" PS 0-50 Feet
50-00 Feet
2" PS
00-200 Feet
2-/2" PS
gas supply piping
L.P.-GAS
PIPE SIZE
" PS
-/2" PS
-3/4" PS