Mounting The Unit On The Wall - steel ZS0389 Manuel D'installation

3.8
Proceed as follows to mount the unit:
•
•
•
•
•
28
Instructions for the installer

Mounting the unit on the wall

rest the fastening bar A on the wall, one per side, according to the distance determined by
adding the desired height h and the unit height 551 mm as shown in the figure;
use a spirit level B to check the horizontal alignment of the two fastening bars A and mark the
two respective drill holes at the end of each;
drill the wall, insert the 8 mm expansion plugs and secure the fastening bars A using the
relative screws;
attach the wall unit to the fastening bars A;
adjust the alignment of the wall unit using the mounting plates (one per side); the top screw C
adjusts the distance from the wall; the bottom one D the vertical slide.