Data Transmission - Alcad 905-TO Serie Manuel D'installation Et Programmation

30 - ENG
On the screen of the level meter will come out the OSD (On Screen Display)
menu of the transmodulator.
Once the transmodulator has been programmed, the Programming Mode
has to be disabled by switching OFF the 'Program' switch. The
'Programming' indicator turns off. The programming indicator will turn off,
the screen of the level meter will come black and after a few seconds the
picture of the selected TV program will be on screen.
5.2

Data Transmission

Select the desired function on the PS programmer screen and adjust the right
value of that function.
To transmit, press the T key. The programming led will blink to indicate that
the receiver has received the data. Besides, the data transmitted will be
stored in the PS programmer.
5.3 OSD Language, output channel and output frequency
selection
Select the language on the PS programmer and in the OSD menu, pressing
F LANG. and F for confirming.
When the
Output channel B/G CCIR C
programmer screen, you could select standard channels meanwhile when
the
Output channel B/G CCIR S
S band channels. Press the C/S key to switch between standard channels
and S band channels.
Installation and programming manual
Fig. 6 - Program mode
TO-559
is displayed in the PS
is displayed you could select